User Manual Q&AAnswer
Dec 25, 2024 - 03:41 AM
To install the GemCoo JYZL009R-IFBA USB Car Charger in your vehicle, please follow these step-by-step instructions:
1. Open the Charger's box: Take the GemCoo JYZL009R-IFBA USB car charger out of the box and make sure all of the parts are in the right place.
2. Learn about the USB Ports: Get to know the two QC3.0 USB charging ports, which can charge two devices at the same time.
3. Find Your Car's DC Power Outlet: Look for a 12V or 24V DC outlet in your car, like the cigarette lighter plug, where you want to put the charger.
4. Get ready for installation: Figure out where the charger will work best in your car. You can mount it vertically, horizontally, or under the dashboard, based on your preference.
5. Connect the Wires: To make sure the circuit works right, connect the "+" (positive) wire to the positive terminal and the "-" (negative) wire to the negative terminal.
6. Touch the On/Off Switch: The charger has an on/off switch that you can press to control the power. To save power, turn it off when not in use.
7. Safely Attach the Charger: Use screws or glue to firmly attach the charger to a flat surface so it doesn't get disconnected by accident.
8. Connect to USB Devices: To charge your phones, tablets, and other USB devices, plug them into the ports and make sure they are compatible with QC3.0 for fast charging.
9. Check the LED Light: Once you've connected your devices, look at the blue LED light to make sure the charger is properly hooked up and charged.
10. Once your devices are put in, make sure the charging speed is fast and effective. This is especially important if your devices support QC3.0 charging.
11. Make Sure of the Right Voltage: For the charger to work best, make sure that the car's electrical system gives it the right voltage (12–24V).
12. Watch the Charging Process: The built-in Smart IC technology lets you watch the charging process and make sure the devices are being charged safely.
13. Switch Off When Not in Use: Use the touch switch to turn off the charger when not in use to save energy and keep your car's battery from draining too quickly.
14. Put It on Different Surfaces: The charger is flexible, so you can put it on different surfaces, like the dashboard, the trunk, or under the seat of your car.
15. Safety Check: Before starting the car, make sure that all of the lines and connections are tight and well-insulated so that nothing gets disconnected or short circuits.
By following these installation steps, you should be able to properly install the GemCoo JYZL009R-IFBA USB Car Charger in your vehicle. If you have any further questions or concerns, please refer to the user manual or contact GemCoo customer support for assistance.
Add New Comment