User Manual Q&AAnswer
Dec 24, 2024 - 09:21 PM
To set the target tire pressure on the Accutire MS-4350 Digital Setpoint Tire Gauge, follow these steps:
1. Press the "SET" button to activate all digits until "0.0" appears on the display. The default unit of measure is PSI.
2. Press and hold the "SET" button for 3 seconds to enter the setting mode. The unit of measure (PSI or BAR) will appear and blink. Use the Up/Down button to switch between PSI and BAR. Press the "SET" button to confirm.
3. The default front tire or rear tire will light up and blink. Use the Up/Down button to switch between the front and rear tires. Press the "SET" button to confirm.
4. Use the Up/Down button to change the target number (desired tire pressure) and press the "SET" button to confirm.
5. The second tire will light up. Use the Up/Down button to change the target number and press the "SET" button to confirm.
6. The unit of measurement and target numbers for both tires will light up and stay for about 2 seconds.
7. The Accutire MS-4350 Digital Setpoint Tire Gauge has now been programmed with the target tire pressure. The display will go back to "0.0".
Note: Make sure to follow the tire manufacturer's recommended tire pressure ratings, which are based on "cool" tire temperatures.
Add New Comment