User Manual Q&AAnswer
Dec 24, 2024 - 04:48 AM
To replace the battery in the Hycline B5532 Digital Bike Floor Pump, please follow these steps:
1. Make sure the pump is turned off and disconnected from any power source.
2. Locate the xxxx cover on the back of the digital display panel.
3. Use a small screwdriver to carefully remove the xxxx cover.
4. Once the xxxx cover is removed, you will see the CR2032 button battery.
5. Take note of the battery's orientation (positive and negative terminals).
6. Use a small tool or your fingers to carefully remove the old battery from its compartment.
7. Insert the new CR2032 button battery into the compartment, ensuring it is properly aligned with the terminals.
8. Press the battery down gently to secure it in place.
9. Replace the xxxx cover and tighten the xxxx to secure it.
10. Turn on the pump and check if the digital display is now bright and clear.
Please refer to the user manual for any specific instructions or precautions regarding battery replacement.
Add New Comment