User Manual Q&AAnswer
Dec 24, 2024 - 04:03 AM
To change the measurement units on the Adoric RFS Digital Electronic Vernier Caliper, follow these steps:
1. Make sure the caliper is turned on by sliding the jaws apart.
2. Locate the "unit" button on the caliper. It is usually labeled with the unit symbols (in, mm, etc.).
3. Press the "unit" button to cycle through the available measurement units. Each press will switch to the next unit.
4. Continue pressing the "unit" button until you reach the desired unit of measurement (inches, millimeters, or fractions).
5. The digital display will update to show the selected unit of measurement.
Note: The Adoric RFS Digital Electronic Vernier Caliper can switch between inches, millimeters (mm), and fractions with just one touch of the "unit" button. This feature allows you to easily switch between different measurement systems based on your preference or specific requirements.
Add New Comment