User Manual Q&AAnswer
Dec 24, 2024 - 12:42 AM
To use the Slime 20017 Tire Pressure Gauge to measure tire pressure, follow these step-by-step instructions:
1. Push the button on the gauge to turn it on. The LCD screen will display "0.0" when it is ready to measure PSI. Push the button again to switch to BAR and again for kPa measurements.
2. Make sure the valve on your tire is free of dirt and debris.
3. Push the nozzle of the gauge onto the tire valve. Ensure a good seal is made between the nozzle and valve stem, and that no air is escaping. Listen for any hissing sound of escaping air.
4. Hold the gauge on the valve stem until the reading locks on the display. The gauge will provide an accurate measurement of the tire pressure.
5. Read the pressure displayed on the gauge. You can continue to use the gauge even if the previous reading is still displayed by following the instructions above.
Note: The gauge will shut off automatically after a few seconds of inactivity to save battery life. The electronic module and power cell are factory-sealed in the unit, so there are no user-serviceable parts.
It is important to regularly check your tire pressure using the Slime 20017 Tire Pressure Gauge to ensure optimal safety, performance, and fuel efficiency. Properly inflated tires are safer and last longer. The recommended tire pressure for your vehicle can usually be found on the driver-side door jamb or in the owner's manual.
Please refer to the Slime 20017 Tire Pressure Gauge User Manual for more detailed instructions and information on maintenance and troubleshooting.
Add New Comment