User Manual Q&AAnswer
Dec 23, 2024 - 10:24 PM
To adjust the brightness of the AHCCSD AH-LA-LAMP-GRA-001 Beautiful Magma Lamp, you can use the touch control method. Here are the steps to follow:
1. Make sure the lamp is plugged into a standard electrical outlet and turned on.
2. Locate the touch control area on the lamp. This is usually a small, designated area on the lamp base or near the power cord.
3. Gently touch and hold the touch control area for a few seconds until the lamp responds.
4. Once the lamp responds, you can start adjusting the brightness. To increase the brightness, continue touching and holding the touch control area. The lamp will gradually get brighter.
5. To decrease the brightness, release your touch and then touch and hold the touch control area again. The lamp will gradually dim.
6. Release your touch when you reach the desired brightness level. The lamp will maintain the selected brightness until you adjust it again.
Please note that the touch control area may vary slightly depending on the specific design of the lamp, but the general concept should be the same. Refer to the user manual that came with your AHCCSD AH-LA-LAMP-GRA-001 Beautiful Magma Lamp for any specific instructions or diagrams related to the touch controls.
Add New Comment