User Manual Q&AAnswer
Dec 23, 2024 - 09:17 PM
To install the Pinty 3-9x32 Rangefinder Rifle Scope on your firearm, follow these steps:
1. Start by installing the Red Dot Sight:
a. Unscrew the sight battery cap and insert the three AG3 batteries with the + side up. Replace the cap.
b. Test that the red and green reticles become visible in the reflex lens by pressing their respective power buttons. Turn the reticle off.
c. Loosen the locking bolts on the sight rail mount with the M2 hex wrench. Position the sight on the scope’s top rail with its reflex lens pointing towards the objective lens and away from the ocular lens. Retighten the locking bolts.
2. Install the Laser:
a. Unscrew the laser battery cap and insert the CR2 battery with the + side out. Replace the cap.
b. Test that the laser comes on when its power button is pushed. Turn it off.
c. Loosen the locking bolts on the laser rail mount with the M2 hex wrench. Position the laser on the scope's left rail with its aperture pointing towards the objective lens and away from the ocular lens. Retighten the locking bolts.
3. Install the Scope:
a. Remove the cap from the illumination adjustment xxxx above the eyepiece to expose the scope’s battery compartment. Install the CR2032 battery with the + side up. Replace the cap, pressing and tightening until it locks itself in place.
b. Test that the reticles appear when the illumination adjustment xxxx is turned. Turn them off.
c. Loosen the locking bolts on the scope rail mount with the M3 hex wrench. Position the scope on the riser mount or your firearm’s top rail at a comfortable distance with its objective lens pointing towards the muzzle and away from the stock. Retighten the bolts.
d. Adjust the position of the other accessories as needed.
4. Install the Riser Mount:
a. Manually loosen the locking bolts on the riser mount and place it onto the receiver or rail of your firearm.
b. Retighten the locking bolts until the riser mount is snug but not overly tight.
c. Attach the scope or other accessory to the top of the riser mount as mentioned above. Check the level of the mount and scope to ensure they are aligned with the barrel of the firearm.
d. Tighten each riser mount locking bolt fully, alternating between them as you go. This will ensure that the riser mount is tightened evenly and securely.
Please refer to the user manual for visual diagrams and additional information on the installation process.
Add New Comment