User Manual Q&AAnswer
Dec 23, 2024 - 09:10 PM
To change the battery in the Lantoo ST-A0012 Digital Tire Pressure Gauge, please follow the steps below:
1. Make sure the gauge is turned off and remove it from the valve stem of the tire.
2. Locate the battery compartment on the back of the gauge. It is usually secured with a small xxxx or latch.
3. Use a screwdriver or your fingers to open the battery compartment.
4. Take out the old battery and dispose of it properly according to local regulations.
5. Insert a new battery into the compartment, making sure the positive (+) and negative (-) ends are correctly aligned with the markings inside the compartment.
6. Close the battery compartment securely by tightening the xxxx or latching it back into place.
7. Press the power button to turn on the gauge and check if the new battery is functioning properly.
Note: The Lantoo ST-A0012 Digital Tire Pressure Gauge typically uses a standard CR2032 battery, but it's always recommended to refer to the instruction manual or contact the manufacturer for specific battery requirements and replacement instructions.
For more detailed instructions, please refer to the manual provided with the product.
Add New Comment