User Manual Q&AAnswer
Dec 23, 2024 - 08:05 PM
To change the batteries in the BRIO 33213 Remote Control Train Set, follow these steps:
1. Locomotive: The locomotive requires 2 x 1.5V AA batteries. To access the battery compartment, slacken the xxxx on the battery cover located on the back of the locomotive. Install the batteries according to the illustration inside the compartment, ensuring the correct polarity (+/-). Close the battery cover and tighten the xxxx .
2. Remote control: The remote control also requires 2 x 1.5V AA batteries. Slacken the xxxx on the battery cover located on the back of the remote control. Install the batteries according to the illustration inside the compartment, ensuring the correct polarity (+/-). Close the battery cover and tighten the xxxx .
Important notes:
- An adult should install and change the batteries.
- Never try to recharge non-rechargeable batteries.
- Remove rechargeable batteries before recharging.
- Rechargeable batteries should only be charged under adult supervision.
- Never mix battery types or mix new and old batteries.
- Use only recommended batteries of the same or corresponding type.
- Always install the batteries with the correct polarity.
- When the batteries are flat, remove them from the product.
- Do not short-circuit the battery poles.
- Remove the batteries if the product is not to be used for an extended period.
- Discharged batteries and old electrical and electronic products must be disposed of at an approved collection center. Do not treat them as domestic refuse.
- Do not expose batteries to dampness or water.
Please refer to the user guide for more detailed instructions and safety information.
Add New Comment