User Manual Q&AAnswer
Dec 23, 2024 - 06:26 AM
To change the batteries in the VTech 80-190200 Pups to the Rescue Driver, please follow these steps:
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit.
3. Use a screwdriver to open the cover.
4. Install 2 new "AA" size (LR6/AM-3) batteries following the diagram inside the battery box. It is recommended to use new, alkaline batteries for maximum performance.
5. Replace the battery cover and tighten the xxxx to secure.
Note: If there is no response when the unit is switched on, please insert new batteries and try switching it on again.
It's important to follow these instructions to ensure proper battery installation and optimal performance of the toy.
Add New Comment