User Manual Q&AAnswer
Dec 23, 2024 - 05:18 AM
To change the light mode on the EULOCA Battery Powered LED Camping Lantern, follow these steps:
1. Make sure the lantern is turned on by pressing the power button located on the front or top of the lantern.
2. Once the lantern is turned on, press the power button again to cycle through the different light modes.
3. Each press of the power button will switch the lantern to the next mode in the following order: Daylight White (6000K), Warm White (3000K), Combined Light (Daylight White + Warm White), and Flash Mode (SOS Blinking).
4. Continue pressing the power button until you reach the desired light mode.
5. To turn off the lantern, press and hold the power button for a few seconds until the light turns off.
Please refer to the "Features" section of the user manual for more information on the different light modes and their uses.
Note: If the lantern is not switching between modes or the light is not functioning properly, please refer to the "Troubleshooting" section of the user manual for possible solutions or contact customer support for assistance.
Add New Comment