User Manual Q&AAnswer
Dec 23, 2024 - 03:27 AM
Installing the Apevia ATX-PR800W Prestige Power Supply is a relatively straightforward process. Here are the step-by-step instructions:
1. Make sure your computer is powered off and unplugged from the power source.
2. Open your computer case by removing the side panel.
3. Locate the existing power supply in your computer and disconnect all the cables connected to it. Take note of where each cable is connected.
4. Remove the existing power supply from your computer case.
5. Take the Apevia ATX-PR800W Prestige Power Supply and place it in the same location where the previous power supply was installed. Make sure it is securely mounted using the screws provided.
6. Connect the 24-pin connector from the power supply to the corresponding motherboard socket. Ensure it is firmly inserted.
7. If your CPU requires additional power, connect the 4-pin or 8-pin (4+4pin) +12V connector from the power supply to the CPU socket on the motherboard.
8. If you have a dedicated graphics card, connect the appropriate PCI Express connector(s) from the power supply to the graphics card.
9. Connect the 4-pin Molex connectors from the power supply to any hard drives, CD-ROM drives, or cooling fans that require power.
10. If you have any floppy disk or zip drives, connect the 4-pin floppy connector from the power supply to the corresponding drive.
11. If you have SATA hard drives, connect the SATA connectors from the power supply to the SATA drives.
12. Double-check all the connections to ensure they are secure and properly seated.
13. Close your computer case by reattaching the side panel.
14. Plug in your computer and turn it on. The Apevia ATX-PR800W Prestige Power Supply should now be installed and providing power to your components.
Please note that these instructions are a general guide, and it's always recommended to consult the specific user manual for your computer and the Apevia ATX-PR800W Prestige Power Supply for any additional instructions or precautions.
Add New Comment