User Manual Q&AAnswer
Dec 23, 2024 - 02:14 AM
To pair the remote control with the FURORA LIGHTING TY19N010 candles, please follow these steps:
1. Ensure that the candles are turned on by sliding the switch located at the bottom of each candle to the "ON" position.
2. Make sure the batteries in the remote control are properly inserted and functional.
3. Stand within a reasonable range of the candles, typically within 5-10 feet.
4. Press and hold the "ON" button on the remote control for approximately 3 seconds until the candles start to flicker.
5. Release the "ON" button and the candles should now be paired with the remote control.
6. Test the remote control by pressing the various buttons to adjust the brightness, flicker mode, or set timers for the candles.
If the remote control is still not working after following these steps, please refer to the user manual for troubleshooting tips or contact FURORA LIGHTING customer support for further assistance.
Add New Comment