User Manual Q&AAnswer
Dec 23, 2024 - 12:26 AM
To install the Segotep GM750 750W Gold Power Supply, please follow these steps:
1. Remove the power supply from its packaging.
2. (Optional) If you have a PSU testing tool, connect the 24-pin cable to the PSU and attach the testing tool to the cable. Connect the AT power cable to the PSU and plug the PWR cable into the outlet or surge protector/UPS you plan to use. Turn the power switch to the ON position. This step is optional and can be used for testing or bleeding/draining water-cooling components.
3. Use the screws provided with your case to install the power supply into your computer. It is recommended to install the power supply with the fan facing down. However, if your case places the power supply at the bottom and there are no ventilation holes available, it may be best to install the power supply with the fan facing up for greater efficiency and reliability.
4. Connect the 24-pin ATX cable to the PSU and the motherboard.
5. Connect the 4+4-Pin EPS12V cable to the motherboard. If your motherboard supports additional 8-pin or 4-pin CPU power connectors for extreme overclocking or dual CPU configurations, connect the second 4+4-pin EPS12V cable.
6. Connect the 6/6+2-Pin PCI-E cables to your graphics card(s). Make sure not to plug an 8-pin PCI-E cable into a 6-pin connector without detaching the two extra pins.
7. Connect SATA power cables to all data drives or optical drives.
8. Connect the peripheral "Molex" 4-Pin connectors for fans, pumps, legacy components, and other devices/adapters.
9. Connect the AC power cord to your power supply and to the wall. Check all connections to ensure a solid connection, and turn the power switch on the power supply to the ON position.
Please refer to the user manual for any additional information or specific instructions related to your setup.
Add New Comment