How do I assemble and set up the Alpine Corporation TEC106-BZ Water Fountain? (Alpine Corporation Water Fountain Owner’s Manual)

Answer

manuals.plus

Dec 22, 2024 - 11:02 PM

Sure! Here are the step-by-step instructions for assembling and setting up the :

1. Unpack all components carefully and ensure all parts have been removed from the packaging.
2. Place the Fountain Base on a smooth and level surface. Attach the Post Connector to the Fountain Base and xxxx the Post into the Post Connector by twisting clockwise.
3. Fit the Pump (attached to the Fountain Basin) into the Pump Housing on the side with the gap. The Pump cord should fit into the gap.
4. Insert the Pump Housing pipe into the hole on top of the Pump. Rotate the nut and washer on the pipe until they are tight at the top of the Pump Housing. Ensure that the rectangular guide is flush with the raised areas and the bottom of the Pump is flat against the base of the Pump Housing.
5. The Pump power is controlled with the grey switch.
6. Locate the Pump power cable and feed it through the top of the Post. Pull the Pump power cable out of the hole under the Fountain Base.
7. Attach the Fountain Basin by twisting it onto the Post. Ensure it is level before proceeding. Place the washers on the holes of the Fountain Basin. Run the cord through the gap of the Pump Housing. Align the holes of the Pump Housing and the holes of the Fountain Basin and washers, and tighten the screws.
8. Place the Pump Cover around the Pump Housing. Place the Lower Tier on the Pump Housing pipe and press down until it fits into the top of the Pump Cover hole. Place the Dish Cover on the Pump Housing pipe followed by the Upper Tier. xxxx on the Top piece.
9. Fill the Fountain Basin with 1 gallon of water, being careful not to overflow and cause splashing. Make sure the water completely submerges the pump. We recommend using distilled water to prevent scale build-up.
10. Plug the Pump power cable into your local power supply, and the water will start flowing.
11. Use the Ground Stakes when placing your fountain on uneven soil and/or to secure it.
12. Congratulations, your fountain is now complete. Be sure to add water regularly as water will evaporate.

Please refer to the Alpine Corporation TEC106-BZ Water Fountain Owner's Manual for more detailed instructions and safety precautions.