User Manual Q&AAnswer
Dec 22, 2024 - 10:55 PM
To assemble the Teamson Home YG0037A Glazed Pot Water Fountain, follow these steps:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the main body on a flat, level surface. From the opening at the back of the fountain, insert the water supply tube into the pump outlet on the top of the pump and connect the LED lights with the light cable separately. Then place the pump upright into the basin. Connect the pump cord with the transformer. (Step 1 & Step 2)
4. Add clean water into the basin. The water level should be approximately 1 inch (25 mm) lower than the top edge of the opening at the back of the basin. After that, connect the transformer to a GFCI outlet and the product will begin to function as intended. (Step 3)
5. If the pump runs with low or high water circulation, check and adjust the regulator dial or slide on the front of the pump. Adjust the dial/slide towards (+) to increase water flow or towards (-) to decrease water flow.
6. The LED lights were pre-assembled, but they are replaceable. When replacing them, please refer to Step 1.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area where it cannot be damaged or cause damage.
8. Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.
Please refer to the complete instruction manual for more detailed information and diagrams.
Add New Comment