User Manual Q&AAnswer
Dec 22, 2024 - 05:10 AM
To sync the remote control with the Click N' Play JJ8833-1 Remote Control Scooter, follow these steps:
1. Make sure both the remote control and the scooter have fresh batteries installed.
2. Turn on the power switch on the scooter.
3. Press and hold the power button on the remote control for a few seconds until the LED light on the remote control starts flashing.
4. Within 10 seconds of the LED light flashing, press and hold the power button on the scooter until the LED light on the scooter starts flashing.
5. Release both buttons and wait for a few seconds. The LED lights on both the remote control and the scooter should stop flashing and remain steady, indicating that they are now synced.
6. Test the remote control by pressing the forward, backward, and loop buttons to see if the scooter responds accordingly.
If the remote control still does not work after following these steps, try replacing the batteries with fresh ones and repeat the syncing process. If the issue persists, refer to the troubleshooting section of the user manual or contact the manufacturer for further assistance.
Add New Comment