User Manual Q&AAnswer
Dec 22, 2024 - 03:22 AM
To adjust the pressure on the TOPDEEP Heat Press Machine, follow these steps:
1. Locate the pressure xxxx on the machine. It is usually located on the top or side of the heat press.
2. Turn the pressure xxxx clockwise to increase the pressure or counterclockwise to decrease the pressure. Start with a lower pressure setting and gradually increase it until you achieve the desired results.
3. Test the pressure by placing a piece of scrap material between the heating plate and the bottom pad. Close the heat press and apply pressure. Check the imprinted design on the material to see if it is evenly transferred. If the pressure is too light, increase it slightly. If the pressure is too heavy and causes distortion or damage to the material, decrease it.
4. Continue adjusting the pressure until you find the optimal setting for the specific material and thickness you are working with.
Note: It is important to adjust the pressure according to the material and thickness being used to ensure proper heat transfer and avoid damaging the material. Always test the pressure on a scrap piece of material before applying it to your actual project.
Add New Comment