User Manual Q&AAnswer
Dec 21, 2024 - 11:39 PM
To assemble the Fisher-Price DJD09 Crawl Around Car, please follow these steps:
1. Fit the rear fenders onto the rear wheelbase. Push each rear fender in place until it "snaps" into place. Note that each rear fender is designed to fit in a specific way, so if it doesn't seem to fit, try the other rear fender.
2. Fit the trunk into the slots in the rear wheelbase. Push it in until it "snaps" into place.
3. Fit the tabs on the seat back into the slots in the trunk.
4. Insert two screws into the seat back and tighten them.
5. Fit the side panels onto the front and rear ends of the car assembly.
6. Insert nine screws into the side panels and tighten them.
7. Carefully turn the car assembly over.
8. Fit the side base to the front and rear end of the car assembly.
9. Insert six screws into the side base and tighten them.
10. Turn the car assembly upright.
11. Fit the peg on the door into the hole in the car. Push it in until it "snaps" in place.
12. Apply labels 7 and 8 to the windshield before completing the next step. Make sure to apply the labels exactly as shown in the illustration and avoid repositioning them after they have been applied.
13. Fit the windshield onto the dash and push it in until it "snaps" into place.
14. Fit the windshield on the dash into the slot in the front end of the car assembly.
15. Carefully turn the car assembly over.
16. Insert four screws into the front end and tighten them.
Once you have completed these steps, your Fisher-Price DJD09 Crawl Around Car should be fully assembled and ready for play. If you have any further questions or need additional assistance, please refer to the instruction manual or contact Fisher-Price's consumer assistance line provided in the manual.
Add New Comment