User Manual Q&AAnswer
Dec 21, 2024 - 01:45 AM
To insert a glue stick into the Dewalt DWHTGR50 Ceramic Glue Gun, please follow these steps:
1. Plug your glue gun into an electrical outlet.
2. Open the fold-away stand by taking hold of the flanges on both sides of the stand and pulling it forward until it locks into position.
3. Make sure you are using a standard 1/2-inch or 12mm diameter glue stick.
4. Insert the glue stick into the glue gun, pushing it into the chamber until it is fully seated.
5. Wait for approximately 2 minutes to allow the glue and glue gun to heat up initially.
6. Once the glue is heated, you can start using the glue gun by pulling the trigger. The amount of glue dispensed is determined by how far you pull the trigger.
7. After use, unplug the glue gun if it will not be used within a 30-minute period.
Please refer to the Dewalt DWHTGR50 Ceramic Glue Gun Instruction Manual for more detailed information and safety precautions.
Add New Comment