User Manual Q&AAnswer
Dec 20, 2024 - 04:11 AM
To change the battery in your eOUTIL DL134-UNC Digital Angle Gauge, please follow these steps:
1. Make sure the device is turned off. Press and hold the power button until the screen turns off.
2. Locate the battery compartment on the back of the gauge. It is usually secured with a small xxxx .
3. Use the screwdriver that came with the kit to remove the xxxx and open the battery compartment.
4. Take out the old battery from the compartment. It is typically a CR2032 battery.
5. Insert a new CR2032 battery into the compartment, making sure the positive (+) side is facing up.
6. Close the battery compartment and secure it with the xxxx .
7. Press the power button to turn on the gauge and check if the new battery is working properly.
Note: It is recommended to use a fresh battery from a reputable brand to ensure optimal performance. If you are unsure about the battery type or need further assistance, refer to the instruction manual or contact eOUTIL customer support for guidance.
Add New Comment