User Manual Q&AAnswer
Dec 20, 2024 - 03:26 AM
Calibrating the Neoteck NTK146 Digital Angle Finder is a simple process. Here are the steps to calibrate the device:
1. Power on the angle finder by pressing the power button.
2. Place the angle finder on a flat and level surface.
3. Press and hold the zero button for a few seconds until the display shows "CAL".
4. Release the zero button and wait for the display to show "0.0".
5. The angle finder is now calibrated and ready for use.
It is important to note that calibration should be performed periodically to ensure accurate measurements. If you notice any inconsistencies or inaccuracies in the readings, you may need to recalibrate the device. Refer to the user manual for more detailed instructions on calibration and troubleshooting.
Add New Comment