User Manual Q&AAnswer
Dec 19, 2024 - 05:29 AM
To mount the Lowrance 000-14193-001 TripleShot Transom Bracket, you have several options depending on your boat and installation preferences. The transducer can be mounted on the transom, jackplate, or step.
Here are the steps to mount the transducer using the transom bracket:
1. Snap the plug to the bracket and attach the bracket and name tag insert to the transducer using the supplied screws.
2. Loosely attach the bracket with the transducer to the transom mounting plate using the supplied bracket assembly bolt, washer, rubber spring washer, and nylon lock nut.
3. Hold the whole assembly up against the transom or transom step to the desired position. If mounting on the transom, align the bottom of the transducer with the bottom of the boat. Use a pencil to mark the pilot holes. The transom mounting plate has xxxx slots for adjusting the transducer position height.
4. Drill the pilot holes and apply a marine high-grade above- or below-waterline sealant/adhesive compound to the pilot holes.
5. Disconnect the transom mounting plate from the transducer bracket and xxxx the transom mounting plate to the transom using the supplied screws and flat washers.
6. Run the transducer cable up through the grommet on the mounting bracket.
7. Reattach the transducer bracket to the transom mounting plate.
8. Set the transducer to the desired angle and tighten the bracket assembly bolt and nylon lock nut.
9. Snap the cable cover into place. If needed, you can remove the cable cover by inserting a flat head screwdriver along the curved edge and pry the clip loose on both sides, one side at a time.
10. Route the cable to the display and connect it to the sonar port.
Please note that these instructions are a summary and it is important to refer to the user manual for detailed instructions and any specific requirements for your boat and installation.
Add New Comment