How do I install the Stern Pad - Standard Size - Black - Screwless Transducer/Acc. Mounting Kit? (SEAWORTHY INNOVATIONS Stern Pad Instruction Manual)

Answer

manuals.plus

Dec 19, 2024 - 04:30 AM


To install the Stern Pad - Standard Size - Black - Screwless Transducer/Acc. Mounting Kit, follow these steps:

1. Choose a suitable location for mounting the transducer or accessory. It is recommended to refer to the transducer mounting instructions provided by the top transducer manufacturers for specific guidance.

2. Clean the mounting area on the boat hull using the included 3M Scotch-brite pad and alcohol wipe. Ensure the surface is dry and free from any dirt or debris.

3. Peel off the backing from the 3M VHB adhesive on the Stern Pad mounting block.

4. Press the Stern Pad firmly onto the cleaned and prepared surface, ensuring it is aligned properly.

5. Hold the Stern Pad in place for a few seconds to allow the adhesive to bond securely.

6. Install the transducer or accessory onto the Stern Pad according to the manufacturer's instructions.

7. Use the included screwless cable clips to secure any cables or wires to the Stern Pad. The cable clips also utilize the 3M VHB adhesive for a secure attachment.

8. Allow the adhesive to cure for 24 hours before using the boat.

Note: The Stern Pad can be painted if desired, and it can be removed from gel-coat if needed.

For more detailed instructions and illustrations, please refer to the included instruction manual provided with the Stern Pad - Standard Size - Black - Screwless Transducer/Acc. Mounting Kit.