User Manual Q&AAnswer
Dec 19, 2024 - 01:56 AM
The installation process for the BESIGN Ground Loop Noise Isolator is simple and straightforward. Here are the steps to install it:
1. Start by identifying the audio source that is causing the ground loop noise issue. This could be a Bluetooth speaker, a car stereo, or any other device with a 3.5mm audio jack.
2. Locate the 3.5mm audio jack on the device and plug one end of the included 3.5mm audio jack cable into it.
3. Take the other end of the 3.5mm audio jack cable and plug it into the input jack of the BESIGN Ground Loop Noise Isolator.
4. Once the isolator is connected to the audio source, you can now connect the output jack of the isolator to your speakers or car audio system using another 3.5mm audio cable.
5. Ensure that all connections are secure and properly plugged in.
6. Power on your audio source and speakers/car audio system.
7. The BESIGN Ground Loop Noise Isolator will now work to eliminate any ground loop noise and interference, providing you with clear and clean audio.
Note: It is important to follow the instructions provided in the user manual for the specific installation steps and any additional information or troubleshooting tips.
Add New Comment