User Manual Q&AAnswer
Dec 19, 2024 - 01:38 AM
To program the Big-Autoparts 2 Replacement Keyless Entry Remote Key Fob Clicker for your Ford F-150, you can follow the steps below:
1. Insert the first previously programmed key into the ignition.
2. Turn the ignition key to the on position and leave it on for at least three seconds, but no longer than ten seconds.
3. Remove the first programmed key from the ignition and turn it off.
4. Insert the second previously programmed key into the ignition within three seconds but before ten seconds have passed since the ignition was turned off.
5. Turn the ignition key to the on position and leave it on for at least three seconds, but no longer than ten seconds.
6. Remove the second previously programmed key from the ignition and turn it off.
7. Insert the new unprogrammed key into the ignition within three seconds but no more than ten seconds after turning off the ignition and removing the previously programmed key.
8. Turn the ignition key to the on position and keep it on for at least six seconds.
9. Turn off the ignition with the newly programmed key. If the key is programmed correctly, it will start the car and operate the remote entry system (if the new key is an integrated key head transmitter). Wait for 10 seconds before repeating the steps if the key was not programmed correctly.
Please note that these programming instructions are specifically for the Ford Fusion 2006 model. If you have a different Ford model or year, the programming steps may vary. It is always recommended to consult the vehicle's owner's manual or contact a professional locksmith for accurate programming instructions.
Add New Comment