User Manual Q&AAnswer
Dec 19, 2024 - 01:22 AM
To install the rear camera of the WOLFBOX 12" Mirror Dash Cam Backup Camera, follow these steps:
1. Find the best location to tear off the 3M adhesive on the rear camera and fix the rear camera near the car license plate lamp. If you need to adjust the angle, attach the rear camera bracket to the rear camera and tighten it with screws first.
2. Remove the inner panel of the trunk to expose the rear wiring compartment of the car. Open the trunk and look for a sturdy inner panel covering the other side of the license plate installation area. Insert a decorative removal tool or another thin device behind the panel and pry it apart.
3. Use a trim removal tool to pop out the tailgate trim, then run the cable from outside of the car into the trunk of your car.
4. Connect the rear camera's power cable to the extension cable. After snaking your rear camera's extension cable, connect the power cable to your rear camera's extension cord. If your car has its own reversing assist system, please ignore the red wire on the rear camera cable.
5. Route your rear camera's power cable to the front of the car. If desired, use a trim removal tool to pop out the headlining panel directly above your windshield. Then, run your cable through the exposure chamber.
6. Power on the dashcam with the included car charger. Note that you should not charge it with your own chargers.
Please refer to the complete instruction guide provided with the product for more detailed information and illustrations.
Add New Comment