User Manual Q&AAnswer
Dec 18, 2024 - 03:51 AM
To replace the batteries in the FOBELISK Electric Fly Swatter, please follow these steps:
1. Open the handle: Locate the battery compartment on the handle of the swatter. It is usually located at the bottom or on the side of the handle.
2. Remove the battery cover: Use your fingers or a small screwdriver to gently pry open the battery cover. Be careful not to apply too much force to avoid damaging the cover or the swatter.
3. Insert new batteries: Take two fresh AA batteries (type R6) and insert them into the battery compartment, making sure to align the positive (+) and negative (-) ends correctly according to the markings inside the compartment.
4. Close the battery cover: Once the new batteries are inserted, carefully close the battery cover by aligning it with the compartment and pressing it firmly until it snaps into place.
5. Test the swatter: Press the button on the handle to turn on the electric grid and check if the swatter is functioning properly with the new batteries. You should see a visible electric spark when the button is pressed.
Note: It is recommended to use fresh, high-quality batteries for optimum performance. If the swatter still does not work after replacing the batteries, ensure that the batteries are inserted correctly and have sufficient power. If the issue persists, please refer to the troubleshooting section of the user manual or contact FOBELISK customer service for further assistance.
Add New Comment