User Manual Q&AAnswer
Dec 18, 2024 - 03:24 AM
To install the DooVii LB-004 LED Garage Light, please follow these step-by-step instructions:
1. Unbox the Light: Carefully take the LED garage light out of its package, ensuring you have the light fixture, mounting hardware, and user guide.
2. Pick the Mounting Location: Choose a spot on the ceiling that requires sufficient lighting. Ensure the chosen spot has an E26 plug to accommodate the bulb base.
3. Turn Off Power: Prior to installation, turn off the power at the circuit breaker to ensure safety.
4. Set up the E26 Base: Firmly xxxx the LED garage light into an E26 plug. Verify that the plug fits the light's requirements (E26 base).
5. Place the Light: For optimal coverage, mount the light on the ceiling at the appropriate height. If necessary, adjust the angle to ensure even lighting throughout the area.
6. Tighten the Mounting Fixture: If additional mounting gear, such as brackets, is required, ensure they are securely in place to keep the light fixed in position.
7. Check the Power Supply: Before turning on the power again, inspect the wires and sockets to ensure they are in good condition.
8. Turn on the Power: At the circuit switch, turn on the power again. The light should turn on immediately without any warm-up time.
9. Test the Light: Once the light is installed, it should be tested to ensure it functions correctly and emits the desired amount of light.
10. Position: If necessary, adjust the angle or position of the light to ensure the beam covers the desired area.
11. Check the Beam Angle: Confirm that the 180-degree beam angle evenly illuminates the entire room. Make adjustments as needed to improve coverage.
12. Secure Cords: If the light has any power or extension cords, ensure they are neatly arranged and do not obstruct walkways.
13. Check for Stability: Verify that the light is securely attached and does not move or wobble when touched.
14. Check for Light Modes: Some versions of the DooVii LB-004 LED Garage Light may have different light settings or modes. Ensure the settings are configured to your preference.
15. Final Check: Once the light is installed, give it a final inspection to ensure it is securely in place, functioning properly, and safe to use.
Please refer to the DooVii LB-004 LED Garage Light User Manual for any additional information or specific instructions related to your model.
Add New Comment