How do I install the Pawfly ACB-300 12-Inch Mineral Bubble Stone in my aquarium? (Pawfly ACB-300 Mineral Bubble Stone User Manual)

Answer

manuals.plus

Dec 18, 2024 - 12:43 AM


Installing the Pawfly ACB-300 12-Inch Mineral Bubble Stone in your aquarium is a straightforward process. Here are the step-by-step instructions:

1. Gather the necessary materials: You will need the Pawfly ACB-300 12-Inch Mineral Bubble Stone, the suction cup provided, and a standard 3/16-inch airline tubing.

2. Attach the suction cup: Take the suction cup and wet it with water. Press it firmly onto the back or side of your aquarium, ensuring it is securely attached.

3. Connect the airline tubing: Take the standard 3/16-inch airline tubing and connect one end to the air pump. Make sure the air pump is turned off during this step. Then, insert the other end of the tubing into the connector on the Pawfly ACB-300.

4. Position the bubble stone: Place the Pawfly ACB-300 inside the aquarium, positioning it near the suction cup. The stone should be fully submerged in the water.

5. Secure the bubble stone: Adjust the position of the bubble stone so that it is aligned with the suction cup. Press the suction cup firmly against the aquarium glass to secure the bubble stone in place.

6. Test the setup: Turn on the air pump and check for the release of bubbles from the Pawfly ACB-300. If bubbles are being produced, the installation is successful.

Note: It is important to ensure that the air pump you are using is compatible with the Pawfly ACB-300. The recommended air pump power for optimal performance is 4-6 watts. Also, make sure to regularly clean the bubble stone to prevent any clogs and maintain its efficiency.

For further assistance or troubleshooting, you can refer to the Pawfly ACB-300 12-Inch Mineral Bubble Stone User Manual provided with your purchase or contact Pawfly customer support at support@pawfly.com or 1-800-Pawfly.