User Manual Q&AAnswer
Dec 18, 2024 - 12:02 AM
To install the GloFish 29014 Blue LED Aquarium Light, please follow these steps:
1. Clip the aquarium light into the front of your aquarium. Make sure it is securely attached.
2. Hide the wires using the provided cord routing clips. This will help keep the wires organized and out of sight.
3. Plug in the power cord and make a drip loop. A drip loop is a safety measure that prevents water from traveling along the cord and coming in contact with the electrical components. It is created by allowing a loop of the cord to hang below the level of the receptacle or connector.
Note: For models that have two sticks, the connecting wire must be routed under the tank center brace. Use the cord routing clips to support the cord and prevent it from sagging. The 20-gallon LED light (with two sticks) comes with two clips.
By following these steps, you should be able to properly install the GloFish 29014 Blue LED Aquarium Light in your aquarium. For further assistance, please refer to the user manual or contact customer service at 1-800-526-0650.
Add New Comment