User Manual Q&AAnswer
Dec 17, 2024 - 02:29 AM
To clean the filters on the Eureka 3670M Canister Cleaner Vacuum, please follow the steps outlined in the owner's guide. Here is a complete answer supported by the manual:
1. Turn off and unplug the vacuum cleaner before attempting to clean the filters.
2. Locate the filter cover on the front of the canister. It is labeled "Filter" and has a latch.
3. Press the latch and lift the filter cover to access the filters.
4. There are two filters in the Eureka 3670M Canister Cleaner Vacuum: the motor filter and the dust cup filter.
5. Start by removing the motor filter. It is a foam filter located at the bottom of the filter compartment.
6. Gently pull out the motor filter and rinse it under running water. Squeeze the filter to remove excess water, but do not wring it out.
7. Allow the motor filter to air dry completely before reinstalling it. This may take several hours.
8. While the motor filter is drying, you can clean the dust cup filter. It is a pleated filter located above the motor filter.
9. Remove the dust cup filter from the filter compartment. Tap it gently to remove any loose dirt or debris.
10. Rinse the dust cup filter under running water. Again, squeeze the filter to remove excess water without wringing it out.
11. Allow the dust cup filter to air dry completely before reinstalling it. This may also take several hours.
12. Once both filters are completely dry, place the motor filter back into the filter compartment, ensuring it is properly seated.
13. Insert the dust cup filter back into the filter compartment, aligning it with the guide tabs.
14. Close the filter cover and secure it with the latch until it clicks into place.
15. Plug in the vacuum cleaner and turn it on to check if the suction power has improved.
Note: It is recommended to clean the filters regularly to maintain optimal performance. The frequency of cleaning depends on the usage and the environment in which the vacuum cleaner is operated.
Add New Comment