How do I change the blade on the JOUNJIP ‎JJ-MiniSaw Table Top Miter Cut-Off Chop Saw? (JOUNJIP ‎JJ-MiniSaw Table Top Miter Cut-Off Chop Saw User Manual)

Answer

manuals.plus

Dec 17, 2024 - 01:35 AM

Changing the blade on the JOUNJIP ‎JJ-MiniSaw Table Top Miter Cut-Off Chop Saw is a simple process. Here are the step-by-step instructions:

1. Ensure the saw is turned off and unplugged from the power source for safety.

2. Locate the wrench that came with the saw. This wrench is specifically designed for blade changing.

3. Look for the blade guard on the saw. The blade guard is a protective cover that covers the blade when not in use.

4. Use the wrench to loosen the bolt or nut that holds the blade in place. Rotate the bolt or nut counterclockwise to loosen it.

5. Once the bolt or nut is loose, carefully remove the blade from the saw. Be cautious of the sharpness of the blade and avoid touching the blade directly.

6. Take the new blade and align the center hole of the blade with the arbor of the saw. The arbor is the part of the saw where the blade attaches.

7. Once the blade is aligned with the arbor, insert the bolt or nut through the center hole of the blade and into the arbor.

8. Use the wrench to tighten the bolt or nut clockwise. Make sure it is securely tightened, but be careful not to overtighten.

9. Double-check that the blade is properly aligned and securely attached to the saw.

10. Replace the blade guard by sliding it back into position over the blade.

11. Plug in the saw and turn it on to ensure the new blade is working properly.

Note: Always refer to the user manual for specific instructions and safety guidelines when changing the blade on your JOUNJIP ‎JJ-MiniSaw Table Top Miter Cut-Off Chop Saw.