User Manual Q&AAnswer
Dec 16, 2024 - 10:28 PM
Replacing the cutting wire on the GOCHANGE FMC-02 Foam Cutter Electric Cutting Machine Pen is a straightforward process. Here are the steps to replace the cutting wire:
1. Ensure that the foam cutter pen is unplugged and turned off before proceeding.
2. Locate the cutting wire attachment point on the foam cutter pen. It is usually located at the tip of the pen or near the heating element.
3. Carefully remove the broken or worn-out cutting wire from the attachment point. You may need to unscrew or unclip the wire from the pen, depending on the design.
4. Take the replacement cutting wire and insert it into the attachment point. Make sure it is securely attached and properly aligned.
5. If necessary, tighten any screws or clips to secure the new cutting wire in place.
6. Once the new cutting wire is properly installed, you can plug in the foam cutter pen and turn it on to test the functionality of the new wire.
Note: It is important to use the correct replacement cutting wire specified for the GOCHANGE FMC-02 Foam Cutter Electric Cutting Machine Pen. Using incompatible or incorrect wires may result in poor performance or damage to the foam cutter pen.
For more detailed instructions and illustrations, please refer to the user manual provided with the product.
Add New Comment