User Manual Q&AAnswer
Dec 16, 2024 - 09:59 PM
To install the Netatmo NWA01-WW Wind Gauge for the Weather Station, please follow these steps:
1. Launch the module Manager from the Netatmo smartphone/tablet app or your PC.
2. If using a PC, connect the Weather Station to the PC using the USB cable.
3. If using a smartphone, touch the top of the Weather Station's main module until it blinks blue. This puts the station in Bluetooth mode for configuration from your phone.
4. Select the option "New Wind Gauge" in the module Manager.
5. Remove the batteries from the Wind Gauge and reinsert them. Unscrew the four screws at the bottom base to access the battery compartment.
6. Once the batteries are reinserted, place the Wind Gauge next to the Weather Station, at a distance of about 10 cm / 4 inches.
7. The Weather Station will recognize the Wind Gauge module, and the setup is complete.
8. You can now place the Wind Gauge up to 100m away from the main Weather Station. See the manual for tips on finding the best spot.
Note: It is important not to twist the Wind Gauge and avoid touching the sensors during installation.
For more detailed instructions and illustrations, please refer to the Netatmo NWA01-WW Wind Gauge for Weather Station User Manual.
Add New Comment