User Manual Q&AAnswer
Dec 16, 2024 - 09:15 PM
To pair the Renkchip Z06 Wireless HDMI Transmitter and Receiver, please follow these steps:
1. Ensure that both the transmitter and receiver units are powered on and connected to their respective devices (source device and display device) as described in the user manual.
2. Look for a pairing button or a pairing mode on both the transmitter and receiver units. The location of this button or mode may vary depending on the model, so refer to the user manual or look for any labeled buttons or indicators on the devices.
3. Press and hold the pairing button on the transmitter unit for a few seconds until the pairing indicator starts flashing or changes its behavior. This indicates that the transmitter unit is in pairing mode.
4. Press and hold the pairing button on the receiver unit for a few seconds until the pairing indicator starts flashing or changes its behavior. This indicates that the receiver unit is in pairing mode.
5. Wait for the transmitter and receiver units to establish a connection. The pairing indicators should stop flashing or change their behavior to indicate a successful pairing.
6. Once the units are paired, the audio and video signals should start transmitting wirelessly from the source device to the display device.
If you're still having trouble pairing the devices, please refer to the troubleshooting section of the user manual for further assistance.
Add New Comment