User Manual Q&AAnswer
Dec 16, 2024 - 08:26 PM
To inflate a tire using the Slime 40050 Tire Inflator, follow these steps:
1. xxxx the valve connector onto the tire's valve stem.
2. Plug the power cord into the 12-volt accessory power outlet in your vehicle.
3. Press the on/off button to turn on the inflator.
4. Inflate the tire to the manufacturer's recommended air pressure. You can find the correct tire pressure in your vehicle owner's manual or on the driver's side door jamb.
5. When the proper pressure is reached, press the on/off button again to turn off the inflator.
6. Unplug the power cord and remove the valve connector from the tire's valve stem.
It is important to note that you should not run your vehicle while using the inflator. Additionally, do not use the inflator continuously for more than 10 minutes. Allow the unit to cool for approximately 25 minutes between uses. Always use a pressure gauge to check tire pressure and avoid overinflating.
Add New Comment