User Manual Q&AAnswer
Dec 16, 2024 - 08:12 PM
To program a new PIN code on the M MARANTEC M13-631 Wireless Keyless Entry, please follow the instructions provided in the user manual:
1. Install the batteries provided in the keypad.
2. Press and hold the button on the keypad for at least 3 seconds to activate programming mode. The LEDs on the keypad will light up for 10 seconds.
3. Hold the transmitter (remote control) very close to the keypad buttons and press and hold the transmitter button you use to open and close your garage door. Release the transmitter button when the LED on the keypad flashes.
4. Enter a 4-digit personal identification number (PIN) of your choice using the keypad buttons. For example, enter 1-2-3-4.
5. Press and release the ENTER button on the keypad.
6. The LEDs and keypad buttons will light up for 2 seconds, indicating that the programming is completed.
7. Test the Wireless Keyless Entry by entering the new PIN code and then pressing the ENTER button. The garage door opener should activate.
Note: If you want to program the Wireless Keyless Entry to work with more than one garage door opener (up to 4), repeat the above steps using a new PIN code for each additional garage door opener.
Please refer to the user manual for additional information and troubleshooting tips.
Add New Comment