User Manual Q&AAnswer
Dec 16, 2024 - 10:27 AM
To assemble the Seesii CH600+ 6-inch Mini Chainsaw, follow these steps:
1. Attach the chain to the guide bar: Start by locating the chain tensioning xxxx on the side of the guide bar. Loosen the xxxx to create enough slack in the chain. Place the chain over the guide bar, ensuring that the cutting teeth are facing forward and the chain is properly aligned with the sprocket.
2. Install the guide bar onto the chainsaw body: Align the guide bar with the chain slot on the chainsaw body. Insert the guide bar fully into the slot, making sure it is securely in place. Tighten the chain tensioning xxxx to remove any slack in the chain, but be careful not to overtighten it.
3. Adjust the chain tension: Check the chain tension by pulling the chain away from the guide bar. It should have a slight amount of tension, but still be able to move freely. If the chain is too loose, use the chain tensioning xxxx to tighten it. If it is too tight, loosen the xxxx slightly.
Once you have assembled the chainsaw, you are ready to use it for your cutting tasks. Make sure to refer to the user manual for additional safety precautions and operating instructions.
Add New Comment