User Manual Q&AAnswers
Dec 16, 2024 - 04:54 AM
Cleaning and sanitizing your Avalon A1WATERCOOLER Cooler Dispenser is important to maintain its performance and ensure the safety of the water you dispense. Here are the steps to clean and sanitize the dispenser, as outlined in the user manual:
1. Rinse the inside of the unit: Before cleaning, make sure that the cooling switch (#11) and heating switch (#12) are in the off (O) position, and unplug the machine. Pour water into the top of the unit where the bottle would be placed. Dispense about 2 liters of water from the unit into a bucket by pressing the hot water press paddle (#9) and the cold water press paddle (#6) into a bucket.
2. Drain the water: Place a large bucket beneath the drain outlet (#14) located on the back of the unit. Remove the drain cover and allow the water to drain from the unit. Water will start flowing as soon as the drain cover is removed.
Caution: Please allow ample time for any hot water inside the machine to cool down before draining it.
3. Remove remaining water: Remove any remaining water in the tanks by dispensing water from the hot water spout (#8) and the cold water spout (#5) into a bucket.
4. Clean the cold tank: To remove mineral deposits that may have built up inside the cold tank, mix 4 liters of water with 200g of citric acid crystals (not included) or a cleaning solution of your choice. Twist off the bottle supporter. Put the mixture into the machine's cold tank and make sure the water can flow out of the hot water spout (#8). Plug in the power cord and turn on (I) the heating switch (#12). Allow the water to heat for 15 minutes. Turn off (O) the heating switch (#12) and allow the liquid mixture to cool down for 20 minutes. Drain the liquid from the drain outlet (#14), then flush with water two or three times by following the rinsing instructions above. Only disassemble the parts mentioned to avoid damaging the machine.
5. Reassemble and use: After cleaning and draining is complete, replace the drain cover and use the machine as normal.
Remember to clean and sanitize your Avalon A1WATERCOOLER Cooler Dispenser approximately every six months to ensure optimal performance and water quality.
Dec 16, 2024 - 04:58 AM
To connect your mobile device to the Ruko F11 Pro Drone's Wi-Fi, please follow these steps:
1. Ensure that the drone's batteries are charged and the drone is turned on.
2. On your mobile device, go to the Wi-Fi settings and search for available networks.
3. Look for the Wi-Fi network name starting with "Ruko F11 Pro" or similar.
4. Select the Wi-Fi network and enter the password if prompted. The default password is usually provided in the user manual or on the drone itself.
5. Once connected to the drone's Wi-Fi network, open the Ruko Pro app on your mobile device.
6. Follow the instructions in the app to establish a connection with the drone.
If you are still experiencing difficulties connecting to the drone's Wi-Fi, please refer to page 31 of the user manual for more detailed instructions. Additionally, make sure that your mobile device is compatible with the Ruko Pro app and meets the minimum system requirements. If the issue persists, you can contact Rukodrone@gmail.com or call +1 (949) 394-4635 for further technical support.
Add New Comment