User Manual Q&AAnswer
Dec 16, 2024 - 01:20 AM
To program the Philips SRP3016S/27 remote control, you have two options: Direct Code Entry or Auto Code Search. Here are the step-by-step instructions for each method:
Direct Code Entry (Recommended):
1. Locate the Code List included with your remote. Find the section for the type of device you wish to control (e.g., TV, DVD, Blu-ray, etc.).
2. Circle all the remote codes for the brand of your device in the Code List.
3. Press and hold down the SETUP button on the remote until the red light on the remote control turns on. Release the SETUP button.
4. Press and release the device button on the remote for the type of device you wish to control (e.g., TV, DVD, Blu-ray, etc.). The red light will blink once and remain on.
5. Use the number buttons on the remote to enter the first 4-digit remote code you circled in the Code List. The red light will turn off after entering the fourth digit.
6. Point the remote at the device and test the buttons to see if the device responds. If the buttons do not operate the device, repeat steps 4 and 5 with the next code you circled for that device.
7. Repeat steps 1-6 for each device you wish to control.
Auto Code Search:
1. Manually turn on the device you wish to control.
2. Press and hold down the SETUP button on the remote until the red light on the remote control turns on. Release the SETUP button.
3. Press and release the device button on the remote for the type of device you wish to control (e.g., TV, DVD, Blu-ray, etc.). The red light will blink once and remain on.
4. With the remote pointed at the device, press and release the POWER button on the remote. The remote will send 10 different codes to the device. The red light will blink once for each code and remain on after sending the 10 codes.
5. Did the device turn off?
- If YES, go to Step 6.
- If NO, repeat Step 4 to test the next 10 codes.
6. Manually turn the device back on.
7. With the remote pointed at the device, press and release the VOL UP button. The remote will re-send the first code of the 10 codes from Step 4. The red light will blink once and remain on.
8. Did the device turn off?
- If YES, you have found a code for the device. Press and release the same device button you pressed in Step 3. This will store the code in the remote. Go to Step 9.
- If NO, continue to press and release the VOL DOWN button until the device turns off to test the other 9 codes from Step 4. Be sure to wait approximately 3 seconds after each VOL DOWN button press to allow the device time to respond to the code. When the device turns off, you have found a code for your device. Press and release the same device button pressed in Step 3. This will store the code in the remote. Go to Step 9.
9. Use the remote to turn the device back on and test the buttons to see if the device responds. If the buttons do not operate the device, repeat the Auto Code Search process for each device you wish to control.
Note: These instructions are a summary of the information provided in the Philips SRP3016S/27 Backlit Universal Remote Control User Manual. For more detailed instructions and troubleshooting tips, please refer to the manual.
Add New Comment