User Manual Q&AAnswer
Dec 16, 2024 - 12:43 AM
To install the Monoprice 134706 2-Way In-Ceiling Speakers, follow these steps:
1. Prepare the location:
- Ensure the mounting surface is between 3/8" (9.5mm) and 1 1/4" (31 mm) thick, with at least a 2 3/4 (69mm) clearance behind the mounting surface.
- Use the supplied template to mark the cutout hole size and location for mounting the speaker.
- Use a drywall or keyhole saw to cut the hole.
2. Prepare the speaker:
- If desired, paint the frame and grille before connecting the speaker wire or mounting the speaker.
- To remove the grille for painting, insert a paper clip into one of the grille openings and pull up, or twist the plastic frame back and forth until the grille edge becomes exposed and then lift the grille.
- Carefully remove the dust cloth from behind the grill and replace it after painting.
- Connect the speaker wire after the paint is dry.
3. Connect the speaker wires:
- Route the speaker wire from the receiver to the speaker.
- Separate about 4" (101mm) of speaker wire at each end.
- Use a wire stripper to remove about 1/4" (6mm) of insulation from each wire and twist the ends.
- Connect the marked wire to the red speaker terminal and the unmarked wire to the black terminal. Press the release tab, insert the wire into the hole, and release the tab.
- Connect the marked wire from the speaker to the left channel of the receiver's positive (+) terminal and the unmarked wire to the left channel of the amplifier's negative (-) terminal.
4. Mount the speaker:
- Remove the grille to expose the mounting screws.
- Ensure the mounting tabs are turned in and insert the speaker into the mounting hole.
- Use the four screws to tighten the mounting tabs to the wall or ceiling. Be careful not to over-tighten.
- Replace the grille.
For more detailed instructions and illustrations, please refer to the Monoprice 134706 2 Way In-Ceiling Speakers User Manual.
Add New Comment