User Manual Q&AAnswer
Dec 15, 2024 - 09:40 PM
To install the Peplink ANT-MB-22G-S-B-6 Wi-Fi Antenna system, follow these steps:
1. Identify the antenna ports on your Peplink wireless router or access point. The ANT-MB-22G-S-B-6 system typically includes six antennas, each with a specific purpose (2x LTE/5G, 2x Wi-Fi, 1x GPS).
2. Connect the LTE/5G antennas to the corresponding LTE/5G antenna ports on your device. The antennas use SMA male connectors.
3. Connect the Wi-Fi antennas to the corresponding Wi-Fi antenna ports on your device. The Wi-Fi antennas use RP-SMA male connectors.
4. Connect the GPS antenna to the GPS antenna port on your device. The GPS antenna uses an SMA male connector.
5. Ensure that all connections are secure and properly tightened.
6. Position the antennas in a suitable location for optimal signal reception. For best results, it is recommended to place the antennas in a high and unobstructed location.
7. Once the antennas are properly installed, power on your Peplink device and configure the Wi-Fi settings as needed.
Note: The installation process may vary slightly depending on the specific Peplink device you have. It is always recommended to refer to the user manual or contact Peplink support for detailed installation instructions specific to your device.
For further assistance or troubleshooting, you can reach out to Peplink support at sales@peplink.com or consult the Peplink Certified Partners for expert guidance.
Add New Comment