User Manual Q&AAnswer
Dec 14, 2024 - 04:46 AM
To program your Tabtime Timer Electronic Pill Reminder, follow these steps:
1. Set the time:
- Press the MODE button until you see the clock symbol in the top right-hand corner.
- Press and hold the MODE button until the display flashes.
- Use the HOUR and MINUTE buttons to set the current time.
- Press the MODE button to confirm the set time.
2. Choose 12 or 24 hour clock:
- Press the MODE button until you see the clock symbol in the top right-hand corner.
- Press the HOUR button to switch between 12-hour and 24-hour clock modes.
- Look for a large "P" on the left-hand side of the screen to indicate PM time.
3. Set up to 8 alarms:
- After setting the time, press the MODE button to go to alarm 1 (indicated by a small number 1 with a bell).
- Press and hold the MODE button until the display flashes.
- Use the HOUR and MINUTE buttons to set the desired alarm time.
- Press the MODE button to confirm the alarm is set.
- Repeat this process to set up to 8 alarms.
4. Set the countdown timer:
- Press the MODE button until you see an egg timer symbol on the left of the screen and the display shows 0:00.
- Press the MODE button until the time flashes.
- Use the HOUR and MINUTE buttons to set the countdown time between doses.
- Press the MODE button to stop the time from flashing.
- Press the MINUTE button to start the countdown.
- Press the MINUTE button again to pause and restart the countdown.
- When the alarm sounds, press any button to stop it.
5. Cancelling an alarm:
- To delete an alarm, use the MODE button to navigate to the alarm you wish to delete.
- Press the MINUTE button to delete that alarm.
- To change all settings, remove the battery for a few minutes.
Note: For more detailed instructions and troubleshooting information, please refer to the Tabtime Timer Electronic Pill Reminder Instruction Manual.
Add New Comment