User Manual Q&AAnswer
Dec 14, 2024 - 12:49 AM
Calibrating the JACO Superior Products JSP-014 ElitePro Tire Pressure Gauge is a straightforward process. Here are the steps to calibrate the gauge:
1. Prepare the gauge: Ensure that the gauge is clean and free from any debris or dust. Make sure the gauge is at room temperature before proceeding with calibration.
2. Verify accuracy: To verify the accuracy of the gauge, compare the readings of the gauge with a known accurate pressure source, such as a calibrated pressure gauge or an air compressor with a built-in pressure gauge.
3. Adjust calibration: If the readings on the JACO ElitePro gauge are consistently off by a significant amount, you may need to adjust the calibration. Please note that this step should only be performed by experienced individuals or professionals.
4. Follow manufacturer's instructions: Refer to the instruction manual provided with the gauge for specific calibration instructions. The manual should provide detailed steps on how to adjust the calibration of the gauge if necessary.
5. Test accuracy: After calibration, retest the gauge's accuracy by comparing its readings with a known accurate pressure source. Repeat the calibration process if further adjustments are needed.
It's important to note that the JACO ElitePro Tire Pressure Gauge is already calibrated at the factory and certified accurate within ANSI Standards. Calibration should only be performed if you suspect a significant deviation in accuracy or if you have the necessary expertise to make adjustments. If you are unsure or have any concerns, it is recommended to contact JACO Superior Products directly for further assistance.
Add New Comment