User Manual Q&AAnswer
Dec 14, 2024 - 12:45 AM
To use the AstroAI ASITIG60RH-1 60PSI Tire Pressure Gauge, follow these step-by-step instructions:
1. Remove the protective cap from the gauge.
2. Place the gauge on the tire valve stem.
3. Press down on the gauge until it is securely seated.
4. Read the pressure from the dial.
Here is a more detailed explanation of each step:
1. Remove the protective cap from the gauge: Before using the gauge, remove the protective cap that covers the nozzle.
2. Place the gauge on the tire valve stem: Locate the tire valve stem on your vehicle's tire. Align the nozzle of the gauge with the valve stem and press it firmly onto the stem.
3. Press down on the gauge until it is securely seated: Apply downward pressure on the gauge to ensure a tight seal between the nozzle and the valve stem. This will prevent any air leakage during the measurement.
4. Read the pressure from the dial: Once the gauge is securely attached to the valve stem, observe the analog dial on the gauge. The dial will display the tire pressure reading in the units specified (PSI, Bar, KPa, or Kg/cm²). Take note of the reading for your reference.
It is important to compare the reading to the recommended tire pressure for your vehicle. If the reading is below the recommended pressure, you may need to inflate the tire. If the reading is above the recommended pressure, you may need to release some air from the tire.
Remember to always check the tire pressure when the tires are cold for accurate readings. Additionally, it is recommended to use the gauge on the tire valve stem rather than the tire wall for accurate measurements.
For further information and guidance, please refer to the AstroAI ASITIG60RH-1 60PSI Tire Pressure Gauge User Manual.
Add New Comment