User Manual Q&AAnswer
Dec 13, 2024 - 11:49 PM
To switch between DTE and DCE mode on the OSD RS232 Commercial Amplifier, follow these steps:
1. Locate the DTE/DCE switch on the OSD139A. The switch is located between the optical connectors.
2. Determine whether your host equipment is a DTE (Data Terminal Equipment) or DCE (Data Communications Equipment). This information is typically specified in the user manual or documentation of your host equipment.
3. Set the DTE/DCE switch to the appropriate mode based on your host equipment. If your host equipment is a DTE, set the switch to the DTE position. If your host equipment is a DCE, set the switch to the DCE position.
4. Once the switch is set to the desired mode, the OSD139A will operate accordingly.
Please refer to the OSD RS232 Commercial Amplifier Operator Manual for more detailed information and illustrations on the location and operation of the DTE/DCE switch.
Add New Comment