User Manual Q&AAnswer
Dec 13, 2024 - 09:42 PM
To program the Philips SRP9488C/27 Remote Control to control your TV, you can follow the Direct Code Entry method outlined in the user manual. Here are the step-by-step instructions:
1. Locate the Code List included with your remote. Find the section for the type of device you wish to control (TV in this case). Locate the brand of your TV and circle all the remote codes for that brand.
2. Press and hold down the SETUP button on the remote until the red light on the remote control turns on. Release the SETUP button. The red light will remain on.
3. Press and release the TV button on the remote. The red light will blink once and remain on.
4. Use the number buttons on the remote to enter the first 4-digit remote code you circled in the Code List. The red light will turn off after entering the fourth digit.
5. Point the remote at your TV and test the buttons to see if the TV responds as expected. If the buttons do not operate the TV, repeat steps 2-4 using the next code you circled for your TV brand.
6. Repeat steps 1-5 for each additional device you wish to control with the remote.
Note: If you cannot find a remote code that works for your TV or there are no codes listed for your TV brand, you can try the Auto Code Search method outlined in the user manual.
Remember to refer to the Code List and user manual for specific instructions and troubleshooting tips.
Add New Comment