User Manual Q&AAnswer
Dec 13, 2024 - 08:11 PM
To pair the Dual Electronics XGPS150A with your iPhone, follow these steps:
1. Make sure the mode switch on the XGPS150A is set to the right, away from the USB connector, for use with an iPhone.
2. On your iPhone, go to Settings -> General -> Bluetooth and turn on Bluetooth.
3. Turn on the XGPS150A. The blue Bluetooth status light on the XGPS150A will begin to blink slowly.
4. After a few seconds, the XGPS150A will appear as XGPS150-XXXXXX in the list of devices on your iPhone screen. The last 6 digits are part of the XGPS150A serial number and will be different for each unit. The word "Misc" may also appear for a few moments before XGPS150-XXXXXX appears.
5. Tap XGPS150-XXXXXX in the list of devices to connect to it. The words "Not Paired" will disappear and be replaced by the spinning cursor.
6. After approximately 10 seconds, the XGPS150A name in the device list will change to blue text and the word "Connected" will appear. The blue LED on the XGPS150A will blink rapidly for a few seconds and then stay illuminated, confirming that the two devices have successfully paired and are communicating.
Please note that these instructions were written using iOS version 4.1 and may be different if you are using a different version of the iPhone OS.
Add New Comment