User Manual Q&AAnswer
Dec 13, 2024 - 06:02 AM
Calibrating the VONDIOR 6PSI-A Tire Pressure Gauge is a simple process. Here are the steps to follow:
1. Prepare a known accurate pressure source: Obtain a reliable and accurate pressure source, such as a calibrated air compressor or a precision pressure gauge.
2. Attach the gauge: Connect the swivel chuck of the VONDIOR 6PSI-A to the tire valve stem.
3. Compare readings: Inflate the tire to a specific pressure using the known accurate pressure source. Compare the reading on the VONDIOR 6PSI-A with the reading from the accurate pressure source.
4. Adjust if necessary: If there is a difference between the two readings, use a small screwdriver or similar tool to adjust the calibration xxxx located on the back of the gauge. Turn the xxxx clockwise to increase the reading or counterclockwise to decrease the reading.
5. Recheck and repeat if needed: After adjusting the calibration xxxx , recheck the gauge's reading against the known accurate pressure source. Repeat the adjustment process if necessary until the gauge consistently matches the accurate pressure source.
It is important to note that calibration may not be required frequently, especially if the gauge is handled with care and not subjected to extreme conditions. However, periodic calibration checks are recommended to ensure accurate readings.
Add New Comment